Flexible Faraday Cage Pouch For Your P-SB7 Spirit Box

P-SB11-ANC Is a Dual Channel Spirit Box with advanced Adjustable Noise Control filter (ANC)

The DAS-ANC-PRO Model is a Noise Reduction accessory for the P-SB7 Rev 4 and Rev 5 Spirit Box's. Sweep Noise Removal is adjustable from 0-100%. Your P-SB7 attaches to the rear of the DAS-ANC using velcro (provided). Once attached, simply connect the 3.5mm Audio Input cable to the P-SB7 SPOUT.
Next, Adjust your P-SB7 Volume:
Rev4 or earlier (Blue Display) Volume Level 30
Rev5 (Red Display) Volume Level 19-21
Turn the Speaker ON and attach the Audio Output cable to the X1 Speaker (included). The Speaker attaches to the DAS-ANC using a magnetic mount. Audio is played through a powerful amplified speaker with separate rotating ring volume adjustment. Visual audio representation of Spirit responses is displayed on a bright OLED display which shows the Audio Spectrum and Oscilloscope (Raw) data in real time. As a side note, the DAS-ANC-PRO can be used with ANY type of Spirit Box made by others provided it has an Audio Output. The 3.5mm male Audio Input /Output cables on the DAS-ANC are permanently attached to prevent misplacement. Audio Extension cables can be added by the customer if required.

The New P-SB7T REV6 Includes Integrated Temperature Measurement Display with Ambient and +/- 10 degree Temperature Deviation Measurement is now available effective 02/1/23. The P-SB7T series was originally introduced by Chris Fleming on Ghost Adventures "LIVE" show from the Trans-Allegheny Lunatic Asylum on October 30, 2009.

The ANC-Mini is an Adjustable Noise Control and Spirit Response Amplifying device that can be used with a number of Spirit Box Sweep Radios. Including: P-SB7, P-SB7T, P-SB11, S-Box and many others that offer a separate Audio Output. It is a very Easy To Use device that utilizes two buttons for complete Noise Control.
The ANC-Mini utilizes a proprietary software algorithm that dynamically adjusts the Audio "Hold & Release" properties which enables a more clear Spirit response that can be better heard and deciphered by the user.

INSTRUCTIONS FOR USE:

Adjust your P-SB7 Volume:
Revisions 4 or earlier (Blue Display), set your volume level to 30
Revision 5 (Red Display), set your volume level between 19-21

1. Connect the SPOUT Audio Output from the SB7 Sweep Radio to the Audio Input of the ANC-Mini.
If using the S-Box, connect to the Earphone audio output.
2. Connect the Audio Output from the ANC-Mini to your Speaker. An amplified speaker with separate volume control is best. ANC-Mini With X1 Premium Sound Speaker
3. Press the RED Button until the desired amount of noise is removed from your sweep session.
4. Press the YELLOW Button to increase the noise level.
5. To Reset the ANC-Mini, Press the RED & YELLOW Buttons simultaneously for about two seconds.

*Includes Velcro to attach the ANC-Mini to the back of your P-SB7 and two 4" male audio cables.

The ANC-Mini-X1 is an Adjustable Noise Control and Spirit Response Amplifying device with our best X1 Audio Speaker. It can be used with a number of Spirit Box Sweep Radios. Including: P-SB7, P-SB7T, P-SB11, S-Box and many others that offer a separate Audio Output. It is a very Easy To Use device that utilizes two buttons for complete Noise Control.
The ANC-Mini utilizes a proprietary software algorithm that dynamically adjusts the Audio "Hold & Release" properties which when combined with the X1 Speaker (provided) enables a more clear Spirit response that can be better heard and deciphered by the user. ANC-Mini Without X1 Premium Speaker
Directions For Use:

Adjust your P-SB7 Volume:
Rev4 or earlier (Blue Display) Volume Level 30
Rev5 (Red Display) Volume Level 19-21

1. Connect The SPOUT Audio Output from the SB7 Sweep Radio to the Audio Input of the ANC-Mini.
If using the S-Box, connect to the Earphone audio output.
2. Connect the Audio Output from the ANC-Mini to the X1 amplified speaker with separate volume control. Adjust the X1 outer volume ring to suit your listening preferences.

*Includes Velcro to attach the ANC-Mini to the back of your P-SB7 and two 4" male audio cables.

This is a complete ITC kit that includes the P-SB7T Spirit Box, ANC-Mini Adjustable Noise Control Device and our most popular high end X1 Speaker. It is pre-tested and ready to use out of the box. The ANC-Mini was specifically designed to eliminate sweep noise, which allows the user to hear the Spirit responses more clearly. Be sure to watch our Spirit Response demonstration video below. This kit saves you about 23% compared to buying the individual devices separately.
Includes:
(1) P-SB7T Spirit Box
(1) ANC-Mini
(1) X1 Orbital Speaker
(3) Audio Cables
(1) USB Charge Cable for the Speaker
(3) AAA Alkaline Batteries (P-SB7T)
(2) AA Alkaline Batteries (ANC-Mini)
(1) Velcro Strip to attach the ANC-Mini to the back of your P-SB7 battery cover

Instructions:
1. Adjust P-SB7T (Rev 6.0 and 5.0) to volume level 20. P-SB7 (Rev 4.0) volume level 28-30
2. Connect the SPOUT from the P-SB7 to the ANC-Mini Audio Input
3. Turn the speaker ON using the slide switch located on the bottom. Wait for all speaker audio prompts to stop before proceeding to next step.
4. Connect the Audio output from the ANC-Mini to the Audio Input on the speaker.
5. For best performance Adjust your P-SB7T Sweep rate to 250ms and start sweeping. Note: You can adjust it to suit your individual preferences. But, I have found that the 250ms rate works best with our software algorithm.
6. Turn the ANC-Mini power switch ON
7. Adjust the Master Volume using the Orbital Speaker outer ring. CW increases & CCW decreases Volume. If you hear a beep, you've exceeded the speaker volume limit.
8. The RED Button Removes/Decreases Noise and the YELLOW Button Increases Noise.

Note:
1.The device has been tested and pre-adjusted by our technicians. If you wish to restore/reset the device press the RED & YELLOW buttons simultaneously and then proceed to press the RED button until the noise level suits your preference. You can also observe the RED LED on the top of the ANC-Mini. This LED will begin to blink as you near the optimum setting and it will stay ON when it is set correctly. You can then "Tweak" the RED/YELLOW buttons to get the perfect setting.
2. Be sure that the speaker is fully charged and that your batteries are fresh.

The all aluminum alloy X1 is our very best premium speaker. It is used with the P-SB7 (all versions), P-SB11,  APF Processor, DAS-ANC, and ANC-Mini. The sound quality enables a more clear spirit response that can be better heard and deciphered by the user. There is a volume control ring around the top of the X1 for easy volume adjustment.  1. Rechargeable 600mAh Battery provides up to 6hrs of use.
2. Power Rating: 3.5W
3. Frequency Response: 50Hz-20KHz
4. Speaker: 40mm
5. Uses a Smart switch to select Bluetooth or 3.5mm Line-In
Note: All of our Paranormal Products utilize 3.5mm audio line-in

The New P-SB7T REV6 Includes Integrated Temperature Measurement Display with Ambient and +/- 10 degree Temperature Deviation Measurement is now available effective 02/1/23. The P-SB7T series was originally introduced by Chris Fleming on Ghost Adventures "LIVE" show from the Trans-Allegheny Lunatic Asylum on October 30, 2009.

Created by Gary Galka, the PSB7-PRO design is the first of its kind with result driven features and functionality never before seen or used in a Sweep Radio Spirit Box device.

APF-D Processor Audio Playback Filter Complete Kit Includes:
* (1) APF-D Processor with Graphic Display
* (1) P-SB7T Spirit Box ($84.90)
* (1) X1 Our Best Orbital Speaker ($29.90)
* (2) USB Rechargeable 9Vdc Batteries ($20)
* (1) Bluetooth Transmitter attached to the P-SB7 ($24)
* (1) Bluetooth Receiver attached to the APF-D ($24)
* (1) USB Charge Cable

APF-D Processor Audio Playback Filter Complete Kit Includes:
* (1) APF-D Processor with Graphic Display
* (1) USB Rechargeable 9Vdc Batteries
* (1) Bluetooth Transmitter
* (1) Bluetooth Receiver
* (1) 4:1 USB Charge Cable
* (1) 18" Audio Cable
* (2) 4" Audio Cables
* (2) pcs Velcro

APF-D Processor Audio Playback Filter:
The APF-D Processor is a unique device designed to to be used with any Spirit Box or Audio Recording device with 3.5mm Audio Output. The APF-D allows you to:
* Amplify Audio
* Display The Audio Spectrum
* Pause and Resume Your Spirit Box Session without losing any Response Data
* Playback Feature allows you to Rewind your Responses in 10 second Intervals. You can rewind as far back as you like.
* Adjustable Speed Control allows you to listen to Responses Slower to make deciphering easier. So, if you hear something you can rewind the Response, and then slowly decrease the speed in 5% increments until you can hear the Response more clearly.
* Adjustable Noise Reduction allows you to remove unwanted sweep sounds from your session.
* Adjustable High Pass Filter allows only higher frequencies to pass through

For Deluxe APF-D with ALL Accessories Click Here

IMPORTANT: Tips when using the APF-D Processor

It's important to understand that the APF-D is constantly storing data to memory. If you Start/Stop, Rewind, etc. all the sweep data adds up in the Buffer memory, and this can delay the time it takes for the noise filter setting change to take affect. As such, you must either wait (typically 15-25sec) for the Buffer memory to catch up to the Noise Filter change, or reset the APF device to clear the memory backlog. When I adjust the Noise Filter, I always Reset the APF device by pressing S2+S3 simultaneously to clear the buffer memory. Then my first step is to adjust the Noise filter because this will allow the Noise filter changes to take affect quickly with only minor delays. Once you get into the right Noise filter zone, you can "tweak" the SB7 +/- Volume adjustment to increase or decrease the noise through the filter or adjust the Noise by using the APF-D buttons. Also realize that there are 3 ways to adjust the APF-D Volume. The P-SB7, The APF-D and the outer ring on the speaker. The APF-D volume control will also increase and decrease the audio spectrum gain on the display. Note: the SB7 sweep must be stopped to adjust the SB7 volume.

1.Turn the P-SB7T volume to 20-24
2. Start sweeping
3. Turn the Noise filter immediately to 20.0 to 23.0.
4. Tweak the SB7 volume and APF Noise filter buttons to get the desired results. But be sure to wait 10-20 seconds or so for noise filter to take affect if you do not reset the APF.
5. Be sure your cell phone Bluetooth is OFF to prevent connectivity issues.